Description
The VR8205S2296 is a 24 Vac direct ignition combination gas control from Honeywell's VR8205 series.
The VR8205 is Honeywell's 24 Vac direct ignition dual automatic valve combination gas control, documented in installation instructions form 68-0049 and family instructions form 69-1226. A direct ignition control has no pilot burner: the main burner is lit straight from a spark or hot surface igniter under the command of a separate ignition module, which proves the flame before the valve is allowed to remain open.
The VR8205 is the mid-sized body in the family. Honeywell rates it at 150 cf/h of natural gas at 1 in. wc pressure drop, with a regulation range of 20 to 200 cf/h - 200,000 Btuh at maximum regulation - against 85 cf/h for the smaller VR8105 and up to 415 cf/h for the largest VR8305. Minimum regulation on LP gas is 40,000 Btuh.
Very likely a single-stage control. On Honeywell's closely related VR8215 direct ignition range, form 69-2253 covers the "VR8215S,T Single Stage" controls against the "VR8215Q,N Two Stage" models, with S denoting standard opening and T denoting slow opening. The VR8205 uses the same suffix scheme, so an S here is very likely single stage with a standard-opening regulator - but the VR8205's own Table 3 was not retrieved, so it is flagged rather than asserted in the specification above.
* Brand / Manufacturer: Honeywell
* Model Number: VR8205S2296
* Series: VR8105 / VR8205 / VR8305 Direct Ignition Combination Gas Controls
* Ignition Type: Direct ignition (hot surface or direct spark), no pilot burner
* Suffix Designation: S: single stage, standard opening (per the VR8215 range; not confirmed for VR8205)
* Supply Voltage: 24 Vac, 60 Hz or 50/60 Hz by model
* Body Pattern: Straight through
* AGA Certified Capacity: 150 cf/h natural gas at 1 in. wc pressure drop (4.2 m³/h)
* Regulation Range: 20 to 200 cf/h natural gas; 40,000 Btuh minimum on LP
* Maximum Output: 200,000 Btuh at maximum regulation
* Gas Control Knob: Two position, ON and OFF
* Valve Content: Manual valve, two automatic operators and servo pressure regulator
* Pressure Taps: Inlet and outlet pressure taps provided
* Compatible Modules: S89C, S89E, S89F and S87 series 5 and later
* Condition: New
System notes. The transformer, igniter, flame sensor, ignition module, limit controller and thermostat are all ordered separately. Honeywell pairs these controls with the S89C, S89E and S89F modules and with S87 series 5 and later. Keep the igniter-sensor cable to 3 ft (0.9 m) or less, and do not reverse L1 and L2 - that alone will prevent flame detection. The control contains no replaceable components and must not be dismantled.
Ordering note: Rows 458 and 459 list two further VR8205S controls on different dash numbers, so all three are distinct builds rather than duplicates. Dash number 2296 sits in a different thousand-block from the 2874 and 2890 on those rows, which on Honeywell gas controls usually reflects a different regulator setting or gas configuration. Capacity and connection size for this dash number are not individually published; confirm against the appliance nameplate.
Honeywell / Honeywell
VR8205S2296 / VR8205S2296
VR8205S2296 / VR8205S2296
Warranty Information
B2E Surplus includes a 90-day return window on all orders. If you have any issues with your order, automated returns can be opened by following the instructions located here: https://www.b2esurplus.com/returns/
Subject to the exclusions described below, all B2E Surplus products (“Products”) are warranted to be free from defects in materials and workmanship under normal use and service. Unless otherwise set forth in a quotation or agreed to by B2E Surplus in writing, standard Products are warranted for 90 days from the date of delivery to the buyer.
EXCLUSIVE REMEDY. In the event that B2E Surplus determines that a Product contains a defect in materials or workmanship, then B2E Surplus, in its sole discretion, will (a) repair the Product, (b) replace the Product, or (c) refund the purchase price of the Product. THIS LIMITED WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ALL OTHER EXPRESS AND IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE REMEDY OF REPAIR, REPLACEMENT OR REFUND IS BUYER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. IN NO EVENT SHALL B2E SURPLUS’ LIABILITY UNDER THIS WARRANTY EXCEED THE PURCHASE PRICE OF THE PRODUCT GIVING RISE TO THE WARRANTY CLAIM. All Products which are repaired or replaced shall be warranted only for the unexpired portion of the original warranty period.
EXCLUSIONS. This warranty does not cover (a) any failures which are not attributable to defects in materials or workmanship, including without limitation, failures caused by accidents, inadequate maintenance, misuse, unauthorized modifications or repairs, improper storage, and normal wear and tear, (b) any consumable parts or accessories, such as cutter blades, nut splitter chisels, punches, dies, chains, wedges, and strands, that are designed to wear over time or through use of the Product, or (c) electronics, motors, batteries, and engines, as these items are warranted by their manufacturer.
WARRANTY RETURNS. No Products shall be returned without prior authorization from B2E Surplus. Buyer shall prepay all shipping charges for the return of Products to B2E Surplus’ designated service location.
LIMITATION OF LIABILITY. IN NO EVENT SHALL B2E SURPLUS BE LIABLE FOR ANY INCIDENTAL DAMAGES, CONSEQUENTIAL DAMAGES, SPECIAL DAMAGES, INDIRECT DAMAGES, LOSS OF PROFITS, LOSS OF REVENUES, OR LOSS OF USE, EVEN IF INFORMED OF THE POSSIBILITY OF SUCH DAMAGES. B2E SURPLUS' LIABILITY FOR DAMAGES ARISING OUT OF OR RELATED TO ANY ORDER IS LIMITED TO THE ORDER PRICE FOR THE SPECIFIC PRODUCT THAT GIVES RISE TO THE CLAIM. TO THE EXTENT PERMITTED BY APPLICABLE LAW, THESE LIMITATIONS AND EXCLUSIONS SHALL APPLY REGARDLESS OF WHETHER LIABILITY ARISES FROM BREACH OF CONTRACT, WARRANTY, TORT (INCLUDING BUT NOT LIMITED TO NEGLIGENCE), BY OPERATION OR LAW, OR OTHERWISE.
B2E Surplus LLC is a non-authorized stocking distributor for this brand. We are also known as a ""surplus"", ""discount"", ""liquidator"", or ""gray market"" supplier. We are not a factory-authorized distributor of this product. The Original Manufacturer’s Warranty does not apply. B2E Surplus LLC's standard 90-day warranty will apply. B2E Surplus LLC makes no representations as to your ability or right to download, re-distribute, or otherwise obtain products from this manufacturer, its distributors, or any other source. It is your obligation to comply with the terms of any rules obtaining or installing this product.
Our complete warranty statement page is located here: https://www.b2esurplus.com/warranty/
Our complete return policy page is located here: https://www.b2esurplus.com/returns/